產品型號：351WD12LGC30
光 通：5-6lm
光 強：1500-1700-1900mcd
電 壓：3.0-3.2-3.4V
光源顏色：正白，暖白，冷白
色系色溫：色溫可定制，也可看樣定做！
光 衰：1000H常溫下小於4%
請認準我們的包裝方式和標簽！
請認準我們的外包裝和標簽！
測試環境（遠光的測試儀和星光的老化儀）！
貼片卷盤（3528 2K一卷）
Soldering
| |||||||||||||||||||||||||||||||||||||||||||||
*After reflow soldering rapid cooling should be avoided.
[Temperature-profile (Surface of circuit board)]
Use the conditions shown to the under figure.
＜1 : Lead Solder＞ ＜2 : Lead-free Solder＞
|
[ Recommended soldering pad design ]
Use the following conditions shown in the figure.
Handling of Silicone Resin LEDs |
Handling Indications |
During processing, mechanical stress on the surface should be minimized as much as possible. Sharp objects of all types should not be used to pierce the sealing compound |
|
Figure 1 |
In general, LEDs should only be handled from the side. By the way, this also applies to LEDs without a silicone sealant, since the surface can also become scratched. |
|
Figure 2 |
When populating boards in SMT production, there are basically no restrictions regarding the form of the pick and place nozzle, except that mechanical pressure on the surface of the resin must be prevented. This is assured by choosing a pick and place nozzle which is larger than the LED’s reflector area. |
Dimensions for Tape
Dimensions for Reel
|
Notes:
1.All dimensions are in mm, tolerance is±2.0mm unless otherwise noted.
2.Specifications are subject to change without notice.
Packing
Notes:
1.All dimensions are in mm, tolerance is±2.0mm unless otherwise noted.
2.Specifications are subject to change without notice.
貼片SMD3014 3020 3528 3535 5050專業生產供應商，工廠成立十多年，現共有三傢工廠，專為燈條，模組，燈具廠傢研發低成本高質量的燈珠！完全不用擔憂貨源找不到，質量找不好，價格談不攏的問題。你的選擇您的滿意。歡迎來電咨詢與免費索樣。供深圳工廠貼片生產線給大傢參考，實物拍攝，盜圖必究！
批發市場僅提供代購諮詢服務，商品內容為廠商自行維護，若有發現不實、不合適或不正確內容，再請告知我們，查實即會請廠商修改或立即下架，謝謝。
