Remote controlled socket (learning style)
1.Instuction
on the remote control. open the battery compartment and place the provided battery in the right position
plug the receiver in a power plug. then LED will light. And LED flashes one time per second.
press the ON switch(lasting more than 2 seconds)of you choice on the remote control. the receiver will then learn the code. When LED flashes continuously in 2 seconds and go out, it means the receiver learns the code successfully.
Repeat these last two operations for all receiver selecing a different ON button for each receiver.
When power cut or pull out the receiver from a power plug. you should repeat all the setting above.
2.Operation
Plug the device you want to remotely operate in a receiver.
press the corresponding ON or OFF button of the remote control to operate the plug
press the direct ON/OFF switch on the receiver to operate the plug.
3.Trouble shooting
if a receiver does not react to the remote control operation it can be due to :
Lowbattery in the remote control -replac it
Distancetoo large between the remote control and the receiver
Thepressing time on the buttons must be at least 2 seconds
4.How to decode
press ON/OFF switch on receiver and last for 3 seconds. After the LED flashes from quickly to once per second. decoding is successful.
Press ALL OFF swith on remote control and last for 3 seconds. After the LED flashes from quickly to once per second. decoding is successful.
批發市場僅提供代購諮詢服務，商品內容為廠商自行維護，若有發現不實、不合適或不正確內容，再請告知我們，查實即會請廠商修改或立即下架，謝謝。
