86盒電機控制器說明書

一、接線說明：按電路板上的絲印標示接線

1、電源（AC220V）:LN表示接交流220V的電源輸入。

2、上升（UP）、下降（DOWN）和公共（COM）：這是接交流電機的3根線，分別是公共（COM）接電機的公共線，上升（UP）接電機的上升線，下降（DOWN）接電機的下降線。

二、對碼方式：按遙控器上頻道選擇圓型按鍵，看遙控器上頻道指示燈，選定所需要用的頻道，然後按住接收器上的停止鍵不放，5秒後指示燈閃，然後放開停止鍵，再按遙控器的“上、下、停”任意按鍵，即對碼成功。

三、控制方式：遙控器設有5個頻道，每個頻道學習對碼後，按遙控器的頻道選擇按鍵，看遙控器上頻道指示燈，選定所需要控制的頻道，即可以控制相應的頻道電機，當頻道指示燈全亮時，可控制5個頻道電機。

四、清碼方式：按住接收器上的停止鍵不放，5秒後指示燈閃，繼續按住停止鍵不要放開，再過5秒後，指示燈閃兩下，然後放開停止鍵，即清碼成功。

86 manual motor controller box

                       First, the wiring instructions : marked by printing circuit board wiring

1, power (AC220V): L N said pick 220V AC power input .

2 , rise (UP), decrease (DOWN) and common (COM): This is a three wire connection AC motor , which are common (COM) common line connected to the motor , up (UP) received up line motor decline (DOWN) connected to the motor decline line.

Second, the way the code : Press on the remote control channel selection round button on the remote control to see the channel indicator , the required use of the channel selected , then press and hold the stop button on the receiver and hold for 5 seconds after the indicator light flashes , then release the stop button , then press the remote control 's " up, down, stop" any key , that success of the code .

Third, control: remote control has five channels, each channel after learning the code , press the remote control of channel selection buttons on the remote control to see the channel indicator , the need to control the channel selection , which can control the corresponding Channel motor , when the channel indicator light , can control five channels motors.

Fourth, clear code mode: press and hold the stop button on the receiver and hold for 5 seconds after the lights flash , do not continue to hold the stop button is released , another 5 seconds, the indicator flashes twice , then release the stop button that the success of the Qing code .

新手教學

批發市場僅提供代購諮詢服務，商品內容為廠商自行維護，若有發現不實、不合適或不正確內容，再請告知我們，查實即會請廠商修改或立即下架，謝謝。