a)機器需配置獨立的十六平方三相五線電源、100A以上空氣帶漏電開關在機器旁。

Individual Three-phase and Five-wire per square meter power、and 100A above with leakage protection switch nearby the machine is needed.

b)用規定的電纜通過機器底部的電線入口孔連接到機器相應的電源接線端上，機器電源接線端在機器的側板內。

Connecting the power by the stated cable to the supply terminals through the wire port in the bottom of the machine, you can find out the supply terminals in the side board of the machine.

機器的調試和試運行：

Testing and Pre-Running:

a)     接通電源，合上電源開關機器通電、電源指示燈亮。按下起動按鈕開關機器動行。在第一次運行時先檢查機器傳動電機、風機是否有反轉。如有反轉請把電源的其中兩根相線對調一下連接方式。

Turn on the power and machine, power indicator light turn on. Press “Start” Button to start the machine. Checking the drive motor and wind motor in the first operation. If reversion of the wind motor happened, please exchange the position of two phase lines.