液壓缸采用新的密封材料和緩沖結構，啟動壓力低，運動平穩，密封性好，使用壽命長。前後端蓋采用特殊的電泳漆處理，外觀精美。廣泛用於輕工、化工、紡織、電子、機械等自動化設備中。氣缸內徑選擇方式SELECTION OF CYLINDERID

液壓缸活塞桿上的推力：F1=Π/4×D²×P×β(N)

 液壓缸活塞桿上的拉力：F2=Π/4×(D²-d²)P×β(N)

D:液壓缸筒內徑（活塞的直徑）d:活塞桿直徑

P:油泵壓力  β：負載力（慢速時β=65%,快速時β=80%）

Propulsive force on piston rob of cylinder:F1=Π/4×D²×P×β(N)

Pulling force on piston rob of cylinder:F2=Π/4×(D²-d²)P×β(N)

D:IDofcylinder tube(diameter of piston)   d:Diameter of piston rob

p:Air soyrce pressure β:Load force(slow β=65%,fast=80% )

 液壓缸安裝使用註意事項：

安裝前應先空載條件下試運行，正常後方能安裝。

按使用條件選用安裝形式，安裝時必須註意：

a、耳環安裝、中間軸銷安裝，其作用力應處同一平麵內。

b、法蘭安裝，其作用力與支承中心處在同一軸線上，法蘭與支承座的鏈接應使用法蘭麵承受作用力，而不使其固定螺釘承受拉力。

c、氣缸活塞桿不允許承受偏載荷或橫向荷載，超長行程氣缸，應加支承或導向裝置，接入管前要清除管內贓物，防止雜物進入氣缸。

經常檢查緊固件，及時防止松動脫落。必要時可以調節節流閥，一調整緩沖效果，避免活塞與氣缸蓋碰撞，損壞機件。

pre-running the cylinder under idle load condition before installation,install it after everything is OK.

selec the installation method according to usage condition,pay attention to the following points:

a.The force will be applied pn pne surface when mounting the tongue and middle axle pin.

B.The applied force will be on one axis with the supporting center when mounting flange make the flage bear

the effect instead of its fixing bolt when the flange is connected with the supporting base.

c.The cylinder piston rob is not allowed to bear inclined load or lateral load,cylinder with overlength travel

will add support or guiding device,empty the pipe before connection to avoid dirt enter into the pipe.

Check the fastener regularly to avoid loosening happens.

lf it isnecessary,adjust the throttle valve to regular the buffer errect and aviod the piston to strike with the cylinder

tap to damage the parts.