| 產品介紹： | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
產品尺寸圖：
Notes: 1. All dimensions 1.所有單位是毫米（英寸） 2.允許誤差為正負0.25mm,除非另行通知。 3.規格可能隨時有變化，不另行通知。 4.本數據有效期為六個月 Absolute Maximum Ratings at TA=25℃
Electrical / Optical Characteristics at TA=25℃
Note：1.Luminous intensity is measured with a light sensor and filter combination that approximates the CIE (Commission International De L’Eclairage) eye-response curve. 2.1/2 is the off-axis angle at which the luminous intensity is half the axial luminous and intensity. 3.The dominant wavelength, λd is derived from the CIE chromaticity diagram and represents the single wavelength which defines the color of the device. 4.The IV guarantee should be added ±15%. 特性曲線圖 Forward Current Relative Luminous Intensity IF= f (VF); TA= 25 °C IV/IV(30mA) = f (IF); TA= 25 °C  Reflow Soldering Instructions(回流焊說明) 1.Number of reflow process shall be less than 2 times and cooling process to normal temperature is required between first and Second soldering process. (本產品最多隻可回焊兩次,且在首次回焊後須冷卻至室溫之後方可進行第二次回焊.) 2.When soldering, do not put stress on the LEDS during heating.(高溫焊接時，不能外加壓力在LED上.) 3.After soldering,do not warp the circuit board.(焊接完成後，不能彎曲線路板.) 1>Lead Solder（有鉛回焊）  Recommended Soldering Patter(n推薦焊盤式樣) (單位:毫米)  | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
新手教學
批發市場僅提供代購諮詢服務，商品內容為廠商自行維護，若有發現不實、不合適或不正確內容，再請告知我們，查實即會請廠商修改或立即下架，謝謝。
