| 合作分類 | 發電能源工程 |
12V150AH太陽能膠體蓄電池參數資料
1.電壓
浮充電壓：20℃條件下 13.38—13.80V/unit，溫度調節係數為－18mV/℃/unit
Float charging voltage: below 20℃, 13.38—13.80V/unit, the temperature adjustment coefficientis－18mV/℃/unit
均充電壓：14.28—14.52V/unit
Average charging voltage: 14.28—14.52V/unit
最大充電電流：0.20C10A。
Max. charging current: 0.20C10A
2.產品基本參數Basic Parameters
產品基本參數Basic Parameters | 額定 電壓 V Rated voltage | 額定容量 Aｈ(C10) Rated capacity Aｈ(C10) | 長 L | 寬 W | 槽高 Slot height | 總高 Total heigh | 電池 質量 ±2%Kg Batteryweight ±2%Kg | 輸出結構尺寸 Output structure size |
12 | 150AH | 484 | 171 | 241 | 241 | 42 | ||
3.電池主要電性能參數Main electric performance parameters
電池主要電性能參數Main electric performance parameters | 放電時間Discharge time | ||||||||
10′ | 30′ | 1h | 3h | 5h | 8h | 10h | 20h | ||
225.7 | 122.0 | 83.5 | 36.3 | 24.2 | 17.3 | 15.1 | 7.5 | ||
4.長時放電容量(Ah)Long time discharging capacity (Ah)
型號 Type | C24 | C48 | C120 | C240 | ||
Uf=10.8V | Uf=11.1V | |||||
150AH | 175 | 186 | 200 | 218 | ||
5.充電特性曲線Charge Characteristic Curve
6.不同放電率放電特性曲線Discharge Characteristic Curves at different Rate
7.放電容量與環境溫度關係曲線Discharge Capacity VS Ambient Temperature Curve
8.充電電壓與環境溫度關係曲線Charge Voltage VS Ambient Temperature Curve
9.
9.12V150AH太陽能膠體蓄電池照片
10.工程案例
2010年12月，上海師範大學入口示範項目Dec ,2010,Shanghai Normal university
品名 | 主要組成部分 | 配置 數量 |
風光互補 路燈 Wind and solar hybrid lamp | 80W太陽能板 pv panel | 1 |
60W LED光源light | 2 | |
控制器controller | 1 | |
鉛酸蓄電池 12V150AH battery | 2 |
11.安裝說明；
電池安裝：
1.一般情況下電池串聯使用，若電池必須並聯使用，並聯不宜超過二路。
2.電池安裝時其間距大於3cm,且避光、熱、通風良好。
3.安裝前去除一切個人金屬物件（手機、項鏈等）。
4.應使用絕緣工具，絕緣手套。
5.電池上不可放置金屬工具及硬物件。
6.注意電池極性，謹防反接。
充電方式：
1.浮充使用的充電方式：一般採用恆壓限流，具體數值：25攝氏度時。NP型2025~2030V/單體；GM型2.23~2.25V/只；NM型2.36~2.40V/只。點了顯得在0.2A（C:表示電池的額定容量）以下。當溫度高於或低於25攝氏度時，浮充電壓應校正，校正係數為-3mv/攝氏度單體。
2.循環使用的充電方式：採用恆壓限流方式，電流限定在0.2CA以下，25攝氏度時恆壓值；NP型2.4V/單體，GM型2.35V/單體。當溫度高於或低於25攝氏度時充電電壓值應校正，校正係數為-4mv/攝氏度單體。
3.均衡充電：
均衡充電採用先橫流，後按NP型2.4V/單體，GM型2.35V/單體恆壓充電，充電時間取決於放電深度。
（注；在浮充運動中，當一組電池中出現了個別電池的浮充電壓低於2.2V/CELL方需均衡充電。）
4.補充充電：
蓄電池在運輸和儲存過程因自放電將損失一部分容量，若儲存的時間過長，在投放使用前進行補充電。如果存儲的時間在6個月~1年在恆壓2.25V/單體條件下充電3天。
如果儲存的時間為1~2年，在恆壓2.30V/單體的條件下充電3天。
注意事項：
電池在過充時可能益處含氫的爆炸性氣體，應遠離火源。
1.電池因摔破等原因，使電池內酸液濺到皮膚、衣服上時，立即用大量自來水沖洗。
2.不可用任何有機溶劑清潔電池。
3.每2個月巡檢一次電池，如發現落後電池應及時均衡充電仍落後，須更換同種型號新電池，如發現個別電池溫度過高（高於5~10攝氏度），應立即更換新電池。
4.廢電池應回收利用，不得隨地棄置。
Batteries installed:
1. Usually used, if battery series, parallel to the battery must be more than two parallel unfavorable use.
2. The battery when installation, and their distance than 3cm avoid light, heat, well ventilated.
3. Before installation, remove all personal metal objects (mobile phones, necklace, etc.).
Charging ways:
1. The use of floating filling charging ways: generally USES the constant pressure the current limit and concrete numerical: 25 degrees centigrade. NP 2030V/monomer 2025 to ~ type; GM type 2.23 ~ 225 V/only; NM type 2.40 V/only 2.36 ~. O 'clock appear in 0.2 A (C: indicates that the battery rated capacity) below. When the temperature above or below 25 degrees centigrade, float charging pressure should correction, calibration coefficient for - 3mv/degrees Celsius monomer.
2. Recycle charging ways: the constant pressure the current limit way, current confined, 25 degrees below 0.2 CA when constant pressure value; NP type 2.4 V/monomer, GM type 2.35 V/monomer. When the temperature above or below 25 degrees centigrade recharging voltage value should correction, calibration coefficient for - 4mv/degrees Celsius monomer.
3. Balance charge:
Balanced by first after charging by NP, cross type 2.4 V/monomer, GM type 2.35 V/monomer constant pressure charging, charging time depends on the discharge depth.
(note: in float filling movement, when a group of battery in appeared individual battery charging down to float 2.2 V/CELL must balance charge.) party
4. Supplementary charge:
Batteryin transporting and storing process for self-discharge will lose part of capacity, if stored in a long time, before delivery use complement electricity. If the storage time in six months to one year in constant pressure 225 V/monomer conditions charging for three days.
Note:
The battery in the overcharge -included hydrogen may benefit the explosive gas, should be away from fire.
1. The battery for breaking wait for a reason, make a battery inside acid splashed skin and clothes, and rinse immediately with plenty of water.
2. Do not use any organic solvent cleaner batteries.
3. Once every 2 months inspection, such as the discovery of backward battery charging battery should be balanced, lags behind in new battery same model must be replaced, such as the discovery of individual cells to high temperature (above 5 ~ 10 degrees Celsius), should be replaced immediately new battery.
4. Waste recycling, not battery should be abandoned anywhere.
批發市場僅提供代購諮詢服務，商品內容為廠商自行維護，若有發現不實、不合適或不正確內容，再請告知我們，查實即會請廠商修改或立即下架，謝謝。
