一. 簡介:
A. Introduction:
該機器采用可控矽高速度調節系統,霍爾元件測速采用瞭先進的電子電路,數字顯示清晰,使用方便。
The instrument adopts the silicon controlled high speed regulating system, hall element speed adopted advanced electronic circuit, digital display is clear, easy to use.
二. 機器特點:
2. The instrument features:
1.采用內吸式勻漿結構(內切式刀具),高速度。能進行對不相溶的兩液體之間高效勻漿、乳化、和水中微量有機化合物、脂溶物及有機溶媒可溶性物質的萃取。
1. The structure with suction in homogenate (cutting tool), high speed. Can not miscibility between two liquids of efficient homogenate, emulsification, and trace organic compounds in water and lipid soluble and organic solvent extraction of soluble substances.
2.對各種動物、植物的組織均能達到勻漿和混合的目的。
2. The organization of all kinds of animals, plants, all can achieve the goal of homogenate and mixed.
3.能使細胞膜破裂至分離,並能用不同速度使DNA鏈斷裂成小分子物質。
3. Can make the cell membrane rupture to separation, and can use different speed makes the DNA strand breaks into small molecules.
4.低速時可作攪拌器使用,轉速數字顯示,讀數直觀。
4. When low speed can be used for agitator rotational speed digital display, intuitive reading.
三. 技術參數:
3. Technical parameters:
1.電機轉速:20000轉/分(大勻漿刀:8000-18000轉/分,小勻漿刀:8000-20000轉/分) A:為速度數顯
1. The motor speed: 20000 revolutions per minute (big homogenate knife: 8000-18000 revolutions per minute, small homogenate knife: 8000-20000 revolutions per minute) : A digital display for speed
2.電機功率:185W,連續工作時間≤5分鐘
2. The motor power: 185 w, continuous working time 5 minutes or less
3.電源:220V 50HZ
3. Power supply: 220 v, 50 hz
4.重量:10Kg
4. Weight: 10 kg
四. 機器使用:
4. Instrument using:
機器應放在水平的工作臺麵上,安裝所需的勻漿刀具必須到位,接通電源試機時先用盛有水的杯子或器皿,使梅花刀頭淹沒於水中,打開電源開關,有慢到快地調節速度旋鈕,無明顯的金屬摩擦聲(如有金屬摩擦聲,關閉電源,松開支刀具6M/M支緊螺釘,將外固定套隨機轉向上安裝到位,再擰緊)完畢後方能工作。
Instrument should be placed on levels of the work surface, install the required homogenate tool must be in place, ma chine power supply is connected with sheng has a glass of water first or vessel, the plum flower head submerged in water, open the power switch, there are slow to fast regulating speed knob, no obvious metal grating (such as a metal, shut off the power, the cutting tool with 6 M/M screw loose spending, will be installed on a fixed set of random to outside in place, then tighten) is rear can work.
把需要實驗的植物或微生物切成小塊或小片,放在隨機配備的玻璃器皿中,夾在磁鐵支架(七字形)中間,松開固定電機座8M/M支緊螺釘,慢慢地對準器皿口往下移,使勻漿頭距離器皿底部2-3mm為好,再擰緊8M/M螺釘。
The need to experiment plant or microbial cut into small pieces or small pieces, placed in glass ware provided, sandwiched between magnet bracket (7), loosen the fixed motor seat screw, 8 M/M on vessel mouth to move down slowly, make the homogenate head from 2 to 3 mm at the bottom of the vessel as well, and then screw down the screws. 8 M/M
五. 機器維護:
5. The instrument maintenance:
待長期使用後,高速分散器刀具內的聚四氟乙烯是易損機件,供用戶更換之用。
After long-term use, high speed disperser tool of ptfe is vulnerable parts, for the user to replace.
註意:每次工作完畢,卸下刀具用清水沖洗晾乾。
Note: after each job, unload tool to dry, wash with water.
更多與相關產品歡迎您來電咨詢 010-57462906
批發市場僅提供代購諮詢服務,商品內容為廠商自行維護,若有發現不實、不合適或不正確內容,再請告知我們,查實即會請廠商修改或立即下架,謝謝。