PSU50-133，現貨！歡迎新老客戶聯系我們，林小姐/13760409209.

Drive Type Star Bi-Polar, Constant Current Chopper
Current Rating 0.75A/Phase 1.4A/Phase
Power Requirements AC 100V/ 115V ± 10% 50/60Hz
Power Consumption 2.0A or less 3.5A or less
Input Pulse Type Step and Direction (1P) or CW/CCW (2P) signal, selectable
Input Interface All inputs are opto-isolated
Voltage: L: 0~0.5V H: 4~5V Series Resistance: 390W
Output Interface Opto-isolated Open collector output: 24Vdc 10mA nominal
Operating
Environment Temperature
0 ~ 40°C Ambient temperature
Dielectric Strength No abnormality detected after application of AC 1KV between case and
power input terminals, case and signal I/O terminals, signal I/O terminals
and power input terminals for duration of one minute)
Insulation Resistance 100MW or better with 500V potential applied between case and power input
terminals and signal I/O terminals.
CAUTION:
TO AVOID INJURY BY ELECTRICAL SHOCK AND DAMAGE, DO NOT
TOUCH MOTOR LEAD TERMINALS WHEN POWER IS ON. THE
MAXIMUM MOTOR CHOPPING VOLTAGE WILL APPROACH 140VDC.NO
ConNECTION CHANGES MAY BE MADE WHILE THE DRIVE POWER IS
ON. HAZARDOUS VOLTAGES MAY BE PRESENT AT THESE
TERMINALS.IF THE MOTOR OUTPUTS ARE SHORT CIRCUITED,
SERIOUS DAMAGE TO THE DRIVER WILL RESULT. THIS WILL NOT BE
COVERED UNDER WARRANTY, AND WILL VOID REMAINDER OF THE
ORIGINAL PRODUCT WARRANTY. IF MOTOR LEAD TO TERMINAL
ConNECTION IS TO BE MADE VIA A ConNECTOR SET, DO NOT USE
MALE ConNECTORS OF ANY TYPE TO TERMINATE DRIVER OUTPUTS
TO THE MOTOR. ALWAYS USE FEMALE ConNECTOR ON THE DRIVER
SIDE OUTPUT TO AVOID POSSIBLE SHORT CIRCUIT ACCIDENT.
Driver Installation

新手教學

批發市場僅提供代購諮詢服務，商品內容為廠商自行維護，若有發現不實、不合適或不正確內容，再請告知我們，查實即會請廠商修改或立即下架，謝謝。