迷你舞檯燈

拆箱檢查

感謝您購買本公司的激光產品，請在使用前仔細閱讀本說明書，說明書包含重要的安全建議信息和用戶操作說明，請嚴格按規程操作，以免誤用而導致人身安全或損壞燈具。在收到產品時，請小心取放；檢查產品是否有運輸而可能造成的損壞；並檢查紙箱內以下所有配件：

1．激光燈一台2．交流適配器一個3．說明書一份4．三腳架一個5．遙控器一個

功能介紹

開機：當接上電源打開開關時,可以看到牆上或地上有各種如滿天星星一樣的紅、綠光點,光點會不停的變化。

1．轉速：可以調節電機轉速調節按鍵來調節光點變化速度。當第一次按下Motor按鍵，電機轉速減慢1/2，光點呈柔和轉動狀態；當第二次按下Motor按鍵，電機停止轉動，光點會固定不動;當第三次按下Motor按鍵，電機回到初始轉速，光點在被照射物上快速移動。

2．頻閃：可以調節頻閃按鍵來調節光點的閃爍頻率。當第一次按下Stroboflash按鍵，光點以0.5s的間隔時間閃爍；當第二次按下Stroboflash按鍵，光點以1s的間隔時間閃爍。當第三次按下Stroboflash按鍵，光點回到初始狀態，保持常亮。

3．聲控：可以選擇聲控按鍵，切換到音頻控制模式。當第一次按下Music Auto按鍵，“咪頭”就會感應音頻的高低控制舞檯燈光的亮與滅。

4．遙控：可通過配套遙控器，控制舞檯燈的相關功能。

注意事項

嚴格按本操作說明書所述規程操作，請勿擅自拆卸燈具。本產品僅適用於室內使用，並確保防水，防潮，防震，勿在多塵環境中使用。基於半導體激光器特性，要求工作環境溫度為15~30℃，連續工作兩個小時後，需關閉燈具10分鐘，激光器完全冷卻。防止異物進入機體內，以免導致故障。請勿頻繁開關，以免影響激光燈的使用壽命，並盡量避免長時間開啟。避免用遠望設備觀察激光源，這樣可能增大危險。再次運輸時，請注意防震，最好使用原包裝。

警告

本燈具激光危險等級為Class III B,直接在光束內觀察有危險。該燈具對電源要求110-240V/50-60HZ，若超出此範圍，建議使用穩壓設備，否則將嚴重影響激光壽命。

聲明

本產品在出廠時經過全面嚴格地檢測。所有使用者應嚴格遵守以上所陳述單警告事項和操作說明，任何因誤用而導致對產品的損壞不在本公司保修範圍之內，對忽視操作手冊而導致的故障和問題亦不在經銷商負責的範圍內，任何操作產生的激光對人體損害，本公司不負責任。

規格

電源：交流適配器輸入AC110V~240V/50~60Hz,輸出。激光器：波長532nm,光功率50mw波長650nm,光功率100mw。尺寸：120*92*52mm淨重：0.5KG

Mini Laser Stage Light User Manual
Thank you for using our products .For the sake of safety and better operation of this stage light, please read this manual carefully before using and operating it, lest incur

any personal injury or damage to the stage light.
Package List：
1. Stage Light 1PC 2. AC power supply 1PC 3. Owner’s Manual 1PC 4. Tripod 1PC 5. Remote control 1PC
Basic Operations：
Power On: connect to power, press ON/OFF button to make the stage light work.
Power Off: press ON/OFF button to turn it off when the stage light is at work.
1.Speed adjustment: press MOTOR button firstly, the rotating speed slows down; press secondly, motor stops rotating; press thirdly, motor speed recovery to the initial

setting.
2.Strobe function: press STROBOFLASH button firstly, the laser will flicker every 0.5 second; press secondly, the laser will flicker every 1 second; press thirdly, the

laser will be on steadily.
3.Audio control: press MUSIC AUTO button, enter the Audio control mode, the laser flickers with the rhythm of the music. press again, return to automatic mode.
4.Remote control: the supporting remote control can control related functions of the stage light.
Notice:
1.Please operate the stage light according to the manual strictly.
2.This unit is intended for indoor use only and should be prevented from water, moisture and shake.
3.The working temperature of this unit is 15~30°C, and it must be powered off after continuously working 2 hours to let the laser diode cool down.
4.To keep the body of this unit clean to avoid any unnecessary troubles.
5.Do not turn on and off it frequently and try to avoid making it worked for a long time.
6.Do not use the telescope to watch the laser rays, otherwise will be largen the dangers.
7.You had better use the original package during the transportation.
Warnings:
1.The grade of the laser for it is Class lllB, and will be dangerous if exposure to the eyes directly.
2.The working voltage is AC110~ 240V/50-60HZ,once exceeded this range its lifetime will be shorten.
Statement:
All the stage light are examined strictly before shippment, in that case the user should operate it according to the manual strictly. we and the distributor will not be

resposible for any mistakes cause by the wrong operations.
Specification:
1. Power: AC power supply input AC110 ~ 240V / 50 ~ 60Hz, output DC5.0V/ 1A.
2. Laser generator: wavelength 532nm, power 50mw; wavelength 650nm, power 100mw.
3. Dimension: 120 * 92*52mm.
4. Weight: 0.5 KG

新手教學

批發市場僅提供代購諮詢服務，商品內容為廠商自行維護，若有發現不實、不合適或不正確內容，再請告知我們，查實即會請廠商修改或立即下架，謝謝。